Oricom DTX4200 Duel Receive controller speaker microphone

oricom dtx4200.jpg
dtx4200.jpg
dtx4200_1a.jpg
oricom dtx4200.jpg
dtx4200.jpg
dtx4200_1a.jpg

Oricom DTX4200 Duel Receive controller speaker microphone

450.00

ORICOM DTX4200 DUAL RECEIVE - Controller, speaker, microphone

An Australian First!

Like having two radios in one, the dual receive function allows you to receive and listen to two different channels simultaneously without compromising the regular features you’d expect from a UHF CB Radio. Perfect radio for any vehicle where space is limited.

Simply, install the transceiver out-of-sight as the full functional ergonomic controller speaker mic has all you’ll need to stay connected on and off road.

  • Heavy duty controller speaker microphone IP54 dust and splash resistant
  • Dual receive
  • Heavy duty diecast metal chassis
  • 12/24 volt operation
  • 3 memory groups of 16 channels per group 
  • (PC programmable)
  • Large 96 multi-colour backlit display
  • Back light brightness (5 preset levels plus auto)
  • Fast scanning 80 channels within 3 seconds
  • Rotary volume/channel and squelch control
  • Duplex
  • 38 CTCSS & 104 DCS codes
  • Auto power off (off/1h/2h/4h)
  • 3.5mm external jack (for optional external speaker or PA adaptor)
  • Included in the pack; 2m microphone extension cable, slide in bracket, and mounting hardware 
  • Requires UHF CB Antenna and mounting bracket (not supplied)

GENERALDTX4200

ComplianceAS/NZS 4365:2011

Frequency Range TX/RX476.425 - 477.4125 MHz

Number of TX/RX Channels80 UHF CB Channels (75 voice)

Channel Spacing TX/RX12.5KHz

OperatingmodesSimplex, Repeater TX offset (+750KHz)

Scanning Speed50 msec per channel

AntennaImpedance50 Ohms

Operating Volts nominal13.8VDC to 28VDC

Operating Volts Range10 to 30VDC

Over Voltage ProtectionDiode and Voltage regulator system

Over Current Protection2 AMP fuse

Reverse Polarity ProtectionShunt diode

Frequency stability+/-  5 ppm

TRANSMITTER 

RF Output Power 5 watts max

ModulationF3E(FM)

Maximum deviation 2.5KHz

Spurious Emissions< -30dBm

TX Audio pre-emphasis+6dB/Octave from 300Hz to 3KHz

Current consumption during TX1.7 AMP with 50 ohm antenna termination

RECEIVER 

Circuit TypeDual conversion super heterodyne

Intermediate Frequencies1st IF: 21.4MHz, 2nd IF: 450KHz for Main RX

Maximum usable sensitivity - 123dBm for 12dB SINAD (receiver sensitivity)

Audio output power> 2 Watts at 8 ohm load

RX Audio de-emphasis +6dB/Octave from 300Hz to 3KHz

Signal to Noise Ratio> 40dB

Conducted Spurious Emission > -57dBm

MECHANICAL 

Dimensions (H) X (W) X (D)31 x 128 x 147

Weight

548g transceiver / 200g controller speaker mic

 

Add To Cart